Blog
basic-branded-masthead_1920x300

Skip the Peel!

  • Hardwood Floor Care Tips and Recommendations
  • Blogs
Return to Blog Return to News
Jul 18, 2019

Peeling Hardwood Floor

Is your floor peeling? Can you pull a thin layer of finish off like wallpaper? If a floor is not finished properly, you may run into problems down the road, including a peeling floor. Not only is this unsightly, but it can leave your wood floors susceptible to damage! Here are some helpful questions to ask yourself to determine why your floor is peeling.

1.) Is the peel easy to remove from the wood or is it only loose in specific areas? Use a razor knife to see if the film peels off easily. If the peel is loose all over, the coats were not bonded well between them. If just occasional spots are loose, it is more likely due to some local contamination or condition.

2.) Is the back of the film shiny?  Look at the film piece and note where on the board the failure occurred. The middle of the board can indicate the lower coat was cured or there was not enough abrasion between the coats to maintain a good bond for the next coat.  If the peeling occurred on an edge of a board, it could also mean expansion from moisture issues or improper abrasion.

3.) Is there color on the film? If there was a stain on the floor, look to see if there is color on the peeled film. If so, the stain was not dry when coated … regardless of how long the contractor waited. Also, ask if the contractor double-coated the stain. In most cases, double-coating stain will result in failure to bond, because the internal strength of the stain is weaker than the coating bond.

4.) Is there still finish under the peel or is it bare wood? Test with the razor knife to be sure. If there is still film, then the failure was between coats. If the area is bare wood, then the failure is off the wood.

5.) Are you left with bare wood? If the peeling leaves bare wood, the options are narrowed to a sealer failure, or the wood was not prepared properly before coating. Check the peeling for abrasion marks to determine proper floor preparation, or contact the sealer manufacturer for more information. Proper mechanical abrasion is key to aiding adhesion.

6.) Do the meter readings match or is the floor wet? Check the floor with a moisture meter along with some adjacent wood surfaces such as trim, beams, etc. Moisture issues can cause excessive wood swelling and increase the chances for delamination.

If you answered “yes” to any of these questions, there is a good possibility you have your reason for a peeling floor. If none of these reasons pertain to you and your floor is still peeling, we recommend calling an NWFA Certified Professional.

X